LUBRICATION. -724650065

TM 9-3990-206-14&P

Drycleaning Solvent (P-D-680) is TOXIC and flammable. Wear protective goggles, face

shield, and gloves; use only in a well-ventilated area; avoid contact with skin, eyes, and

clothes, and do not breathe vapors. Keep away from heat or flame. Never smoke when

using solvent; the flashpoint for Type II Drycleaning Solvent is 140 degrees F (60 degrees C)

and Type III Drycleaning Solvent is 200 degrees F (93 degrees C). Failure to do so may

result in injury or death to personnel.

If personnel become dizzy while using cleaning solvent, immediately get fresh air and

medical help. If solvent contacts skin or clothes, flush with cold water. If solvent contacts

eyes, immediately flush eyes with water and get immediate medical attention.

(1) Use drycleaning solvent (Item 14, Appendix E) to clean or wash grease or oil from all metal parts. All

surfaces must be clean to ensure removal of corrosion, soil, grease, or residues.

(2) After cleaning, use cold water to rinse flatrack. Dry all parts thoroughly with a lint-free cloth (Item 4,

(3)

Spot paint all surfaces as necessary (TM 43-0139).

Lubricate hinges, pins, rollers and ISO locks with penetrating oil (Item 9, Appendix E), if necessary.

4-6. LOOSE PARTS INSTALLATION.

The flatrack rollers might or might not be installed on the flatrack upon receipt. If rollers are not installed, proceed as

follows:

(1)

Remove roller from stowed position on flatrack wall.

(2)

Install roller on flatrack using two retaining pins.

(3)

Install one holding pin in each retaining pin.

4-7. INVENTORY AND CONTROL PROCEDURES.

Refer to Appendix C, Components of End Item (COEI) and Basic Issue Items (BII) List and Appendix D, Additional

Authorization List (AAL) for proper inventory and control procedures.

4-3