Raise Wall. (cont)

TM 9-3990-206-14&P

NOTE

Pin may need to be lifted slightly to position into alignment slots.

Ensure flat sides of pin align with flat sides of alignment slots.

(5)

Lift safety catch (9) and collar (10) and slide pin (6) towards hinge (11) until safety catch and collar fit

securely over pin.

(6)

Secure safety catch (9) and collar (10) over pin (6).

Ensure area is free of dirt and debris where pin is installed. Failure to comply will result in

pin being hard to install and damage to equipment.

(7)

Tighten adjusting nut (5) until end of pin (6) is approximately even with outside edge of wall (7).

NOTE

Adjusting nut may have to be adjusted slightly for pin lock to lock properly over adjusting

nut.

(8)

Install lock pin (4) over adjusting nut (5).

(9)

Position mud flap (2) in lower clip (3).

(10)

Repeat Steps (5) through (9) to install remaining pin (6).

(11)

Stow handle, socket and two ratchet straps in stowage box (1).

7-13