|
| |
TM 9-2320-364-34-2
12-68
12-10. INTERMEDIATE STEERING GEAR AND PITMAN ARM REPLACEMENT (CONT).
(10)
Remove lifting device from steering gear (6)
and bracket (10).
(11)
Bend up two locking tabs (21) on locking
ring (22).
(12)
Remove and discard retainer (23), locking
ring (22) and spacer (24) from pitman
arm (5).
Pitman arm is under pressure.
Parts can act as projectiles when
released and could cause severe
eye injury.
NOTE
Note location of two timing
marks in pitman arm.
(13)
Using puller and steel disc, remove pitman
arm (5) from shaft (25).
(14)
Remove puller and steel disc from pitman
arm (5).
(15)
Remove six screws (26) and lockwashers (27)
from bracket (10). Discard lockwashers.
(16)
Remove two screws (28), lockwashers (27)
and washers (29) from bracket (10).
Discard lockwashers.
(17)
Remove bracket (10) and rubber boot (30)
from steering gear (6).
NOTE
Cap and plug holes in steering gear after removal of elbows.
Note location and position of elbows.
(18)
Remove elbow (31) and preformed packing (32) from steering gear (6). Discard preformed packing.
(19)
Remove elbow (33) and preformed packing (34) from steering gear (6). Discard preformed packing.
|
