28-4. TENSION LINK REPAIR. (CONT).
Drycleaning Solvent (P-D-680) is TOXIC and flammable. Wear protective goggles, face
shield, and gloves; use only in a well-ventilated area; avoid contact with skin, eyes, and
clothes, and do not breathe vapors. Keep away from heat or flame. Never smoke when
using solvent. The flashpoint for Type II Drycleaning Solvent is 140 degrees F (60 degrees
C) and Type III Drycleaning Solvent is 200 degrees F (93 degrees C). Failure to do so may
result in injury or death to personnel.
If personnel become dizzy while using cleaning solvent, immediately get fresh air and
medical help. If solvent contacts skin or clothes, flush with cold water. If solvent contacts
eyes, immediately flush eyes with water and get immediate medical attention.
Compressed air used for cleaning purposes will not exceed 30 psi (207 kPa). Use only with
effective chip guarding and personal protective equipment (goggles/shield, gloves, etc). Failure
to comply may result in injury to personnel.
Clean all metal parts in drycleaning solvent.
Dry all parts with compressed air.
Inspect each part for nicks, burrs, scratches or dents.
Replace damaged parts.
Bushing inside diameter must not exceed
2.015 in. (51.18 mm). Replace worn bushings.
Perform Steps (1) and (2) only if
bushings were removed.
Apply grease to outside diameter of four
Using press install four bushings (4) in
tension cylinder (3).
Install four lube fittings (2) and grease caps
(1) in tension cylinder (3).
END OF TASK