Figure 27. Front HEMTT Armor Kit locations.

II106700-5

Rev. B

Page 44

(SEE PARA. V)

Figure 27. Front HEMTT Armor Kit locations.

g. Install the Upper Brush Guard Shim (P/N 106759-1) over the Installation Guides.

h. Feed the LH and RH Wiring Extension Harness through the hole in the Lower Brush

Guard.

k. Using a lift sling and material handling equipment (hoist, forklift, etc.), position the

Upper Brush Guard (P/N 111407-1) onto the Installation Guides, over the installed

Shim, and over the Lower Brush Guard with the "up" arrow (↑) facing the installer.

NOTE

The first and second bolt holes and the sixth and seventh bolt holes from the

passenger-side end of the Upper Brush Guard use two bolts (3/8 - 16 x 4.500

LG), four washers (3/8 ID), and two nuts (3/8 - 16) for proper installation. Hand-

tighten the bolts. (See Paragraph 5.1.6 if the vehicle is equipped with a gun ring

mount.)

At this time, do not install bolts into the bolt holes over the headlight cutouts on

the Upper Brush Guard.

0039 00-54