Install the Front Armor Protection Kit, P/N 106705-3

II106700-5

Rev. B

5.1.3 Install the Front Armor Protection Kit, P/N 106705-3

a. Install the LH and RH Seven-Wire Wiring Pigtail (P/N 111438-4) to extend the

headlight and marker light wires (plug in).

b. Insert the Seven-Wire Wiring Pigtail and the attached Grommet into the Headlight

Cover (P/N 113379-1) on the LH and RH sides.

c. Caulk the inside perimeter of the Headlight Covers with sealant (P/N 104302-1 of

Kit P/N 106701-4).

d. Attach the Headlight Covers (LH and RH using three screws (No. 14 - 0.500 LG) for

each cover (See Figure 26). Start the screws from inside the cab. The cover's holes

are threaded for the No. 14 screw.

P/N 113379-1

Figure 26. Install the Headlight Covers.

e. Using a lift sling and material handling equipment (hoist, forklift, etc.), position the

Lower Brush Guard (P/N 111406-) over the grille area of the front of the cab, and

position the two armor panels (P/N 111426-1) on the Lower Brush Guard, and then

attach the items to the cab using eight bolts (3/8 - 16 x 1.500 LG) and

eight washers (3/8 ID); four bolts and washers are installed on each side of the

Lower Brush Guard. Hand-tighten the eight bolts. Remove the material handling

equipment and lift sling from the Lower Brush Guard (See Figure 27).

f. Install the Upper Brush Guard Installation Guides (studs) (P/N 107430-1 of Kit

P/N 106707-1) into the second threaded bolt hole from each outside end of the

upper skid plate mounting frame. Hand-tighten the studs in place.

0039 00-53