DRAFT
TB 9-2320-364-13&P-1
AC HEATER/EVAPORATOR BLOWER OPERATES BUT NO COLD AIR FROM
DUCTS DURING AC OPERATIONS - Continued
WARNING
Remove rings, bracelets, wristwatches, neck chains, and any other jewelry before working around
vehicle. Jewelry can catch on equipment and cause serious injury. Jewelry or tools may short
across electrical circuits or terminals and cause damage to equipment or severe burns or
electrical shock to personnel.
AC condenser assembly weighs 75 lbs. (34 kg). Do not lift AC condenser assembly without the aid
of an assistant. Failure to comply may result in injury to personnel and/or damage to equipment.
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
VERIFY REPAIR
(1) If disconnected, connect AC harness wires 1154
and 1158 to low pressure switch connectors
(2) If removed, install right ECB side panel and ten
screws (TM 9-2320-364-20).
(3) If removed, install AC condenser motor (WP 0025).
(4) If removed, install cover and four washers,
lockwashers, and screws on AC condenser
assembly (WP 0026).
(5) If removed, install AC condenser assembly and four
screws (WP 0028).
(6) If loose, tighten locknut on cushion clip (WP 0028).
(7) If disconnected, connect AC harness AC condenser
assembly connector (WP 0028).
(8) If disconnected, connect AC harness wire 1435 to
AC connector assembly (WP 0028).
(9) If disconnected, connect AC harness wire 1156 and
1158 to high pressure switch connectors
(10) If removed, install driver side noise panel
(11) If removed, install heater compartment front cover
and four screws (WP 0037).
(12) If removed, install heater compartment access
panel and eight screws (TM 9-2320-364-20).
(13) Start engine (TM 9-2320-364-10).
(14) Operate AC system for 10 minutes at high blower
speed (WP 0004).
(a) If AC system does not provide cold air through
ducts, fault has not been corrected. Shut off
PLSAC160
engine, turn fan control switch and temperature
control switch to off position, and notify
Supervisor.
(b) If AC system provides cold air through ducts,
fault has been corrected.
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
