DRAFT
TB 9-2320-364-13&P-1
AC COMPRESSOR DOES NOT SHUT OFF OR CYCLES CONSTANTLY - Continued
WARNING
Remove rings, bracelets, wristwatches, neck chains, and any other jewelry before working around
vehicle. Jewelry can catch on equipment and cause serious injury. Jewelry or tools may short
across electrical circuits or terminals and cause damage to equipment or severe burns or
electrical shock to personnel.
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
VISUAL INSPECTION
NOTE: Temperature control switch temperature probe
is installed correctly when it is inserted into the AC
evaporator core until it touches the bottom of the
insertion hole.
(1) Remove eight screws and heater compartment
access panel (TM 9-2320-364-20).
(2) Inspect temperature control switch temperature
probe for damage.
(a) If temperature control switch temperature probe
is damaged, replace temperature control switch
(WP 0044). Verify repair, go to Step 15 of this
fault.
(3) Check if temperature control switch temperature
probe is installed correctly.
(a) If temperature control switch temperature probe
is installed incorrectly, reinstall temperature
control switch temperature probe (WP 0044).
Verify repair, go to Step 15 of this fault.
(b) If temperature control switch temperature probe
is installed correctly, go to work package 0015
(AC Does Not Cool or Cools Inadequately).
CONTINUITY TEST
NOTE: If screw attaching AC harness wire 1435 to AC
condenser is painted, remove paint from ground
connection, or disconnect wire 1435 before performing
this procedure.
(1) Set multimeter switch to ohms.
(2) Place positive (+) probe of multimeter on AC
harness wire 1435 at AC condenser assembly
ground connection.
(3) Place negative (-) probe of multimeter on a known
good ground.
(a) If there is no continuity, repair AC harness wire
1435 (see Appendix A) or replace AC wiring
harness (WP 0048). Verify repair, go to Step 15
of this fault.
PLSAC173
(b) If there is continuity, go to Step 6 of this fault.