TB 9-2320-364-13&P-1
4. HEATER/EVAPORATOR INSTALLATION.
This task covers:
a. Heater/Evaporator Installation.
INITIAL SETUP
Models
Supplies (Continued)
All
(5) Bezel
(2) Air Diffuser Ball
Test Equipment
(3) Hose Clamp
(5) Nutsert
None
Circuit Breaker 20 amp
Special Tools
Wire Assembly 10 Gage
Wire Assembly 12 Gage
Nutsert Tool
Wire Assembly 12 Gage
Torque Wrench
Light Source
Supplies
Clip
Bulb
Heater/Evaporator
Light Wiring Harness
Gasket - 1/2 in. x 1/2 in.
Heat Shrink
Straight Fitting
(3) Cable Tie
Straight Fitting
(16) Cable Tie
Insulation
(3) Cable Tie
1300 3M Adhesive
(5) Grommet
Personnel Required
PVC Foam Tape
Three
(6) Lockwasher - 1/4 in.
(6) Screw - 1/4-20 x 3/4 in.
References
Fresh Air Box Opening Cover
None
PVC Foam Tape
(14) Screw - 10-32 x 1/2 in.
Equipment Condition
(12) Lockscrew - 1/4-20 x 1/2 in.
Heater Compartment Center Cover
None
Heater Cable
Special Environmental Conditions
Defrost Cable
Air Conditioner Cable
None
(4) Speed Nut - 3/16 in.
General Safety Instructions
Fan Label
Air Conditioner Temperature Label
None
Rotary Switch Kit
Optic Ribbon
0055-37