|
| |
TM 9-2320-364-20-4
4-81
NOTE
Note location and position of
elbows and tees prior to
removal.
(13)
Remove tee (8) and elbow (18) from
elbows (10) and (16).
(14)
Remove elbows (10) and (16) and
preformed packings (24) from fuel/water
separator (1).
(15)
Remove four locknuts (25), screws (26) and
fuel/water separator (1) from bracket (14).
Discard locknuts.
(16)
Remove two locknuts (27), screws (28) and
priming pump (29).
b.
Installation.
Adhesives, solvents, and sealing compounds can burn easily, can give off harmful vapors, and
are harmful to skin and clothing. To avoid injury or death, keep away from open fire and use
in a well-ventilated area. If adhesive, solvent, or sealing compound gets on skin or clothing,
wash immediately with soap and water.
NOTE
Ensure tees and elbow are installed as noted prior to removal.
(1)
Install priming pump (29) on bracket (14) with two screws (28) and locknuts (27).
(2)
Install fuel/water separator (1) on bracket (14) with four screws (26) and locknuts (25).
(3)
Install two preformed packings (24) and elbows (10) and (16) in fuel/water separator (1).
(4)
Apply sealing compound on threads of tee (8) and elbow (18).
(5)
Install tee (8) and elbow (18) on elbows (10) and (16).
|
