|
| |
TM 9-2320-364-20-4
7-6
7-2. ALTERNATOR REPLACEMENT (145 AMP) (CONT).
(11)
Position pulley (35) in soft-jawed vise.
(12)
Remove and discard locknut (36) from
alternator (31).
(13)
Remove pulley (35) from vise.
(14)
Remove pulley (35) from alternator (31).
(15)
Remove key (37) from alternator (31).
b.
Installation.
Adhesives, solvents, and sealing
compounds can burn easily, can
give off harmful vapors and are
harmful to skin and clothing. To
avoid injury or death, keep away
from open fire and use in a
well-ventilated area. If adhesive,
solvent, or sealing compound
gets on skin or clothing, wash
immediately with soap and water.
NOTE
Perform Steps (1) through (4) if
alternator does not have a
capacitor installed.
(1)
Clean the bottom surface of capacitor (38)
and cover (39) with an equal mixture of
isopropyl alcohol and water, and let air dry.
(2)
Install two sided tape (40) to the bottom of
capacitor (38).
(3)
Position capacitor (38) on cover (39) and
install two lockwashers (41) and nuts (42).
(4)
Press capacitor (38) firmly to cover (39).
(5)
Apply electrical sealant to two terminals on
cover (39).
|
