|
| |
TM 9-2320-364-20-4
7-157
NOTE
Note position of head light assembly prior to removal.
(11)
Remove head light assembly (3) and gasket (25) from truck (26). Discard gasket.
b.
Installation.
NOTE
Right side and left side headlight assemblies are installed the same way. Right side is shown.
(1)
Position head light assembly (3) and gasket (25) on truck (26).
(2)
With the aid of an assistant, install three
lockwashers (23) and nuts (22) on studs (24)
at rear of head light assembly (3).
Adhesives, solvents, and sealing
compounds can burn easily, can
give off harmful vapors, and
are harmful to skin and clothing.
To avoid injury or death, keep
away from open fire and use
in well-ventilated area. If
adhesive, solvent, or sealing
compound gets on skin or
clothing,wash immediately with
soap and water.
(3)
Apply corrosion preventive compound to
connectors on wires 1007 (16), 1006 (18)
and 1435 (20).
(4)
Connect wire 1007 (16) to connector (17)
on head light assembly (3).
(5)
Connect wire 1006 (18) to connector (19)
on head light assembly (3).
(6)
Connect wire 1435 (20) to connector (21)
on head light assembly (3).
|
