|
| |
TM 9-2320-364-20-4
7-173
Corrosion inhibitor contains
alkali. Do not get in eyes; wear
goggles/safety glasses when
using. Avoid contact with skin. In
case of contact, immediately
wash area with soap and water. If
eyes are contacted, flush eyes
with large amounts of water for
at least 15 minutes and get
immediate medical attention.
(3)
Apply anti-corrosion silicone compound
inside of side marker light socket (10).
(4)
Install lamp (9) in side marker light socket
(10).
(5)
Install cover (8) and two screws (7) in side
marker light (6).
(6)
Position ground wire (21) through hole in
side marker light (16).
(7)
Install LED (20) in side marker light (16)
and turn 1/4 turn clockwise.
(8)
Position gasket (18) and side marker light
(16) on fender (19).
(9)
Install two self-tapping screws (17), ground
wire (21) and side marker light (16) on
fender (19).
(10)
Install cover (15) and two screws (14) in
side marker light (16).
(11)
Connect connector (5) to side marker
light wiring harness (2).
(12)
Install loop clamp (3) and side marker
light wiring harness (2) on rear fender
support arm (4).
(13)
Install cable tie (1) on side marker light
wiring harness (2).
c.
Follow-On Maintenance:
Connect batteries, (Para 7-87).
Remove wheel chocks, (TM 9-2320-364-10).
END OF TASK
14
15
20
17
18
16
19
7
9
8
11
12
13
10
6
3
1
2
5
4
21
|
