|
| |
TM 9-2320-364-20-4
7-193
Corrosion inhibitor contains
alkali. Do not get in eyes; wear
goggles/safety glasses when
using. Avoid contact with skin. In
case of contact, immediately
wash area with soap and water. If
eyes are contacted, flush eyes
with large amounts of water for
at least 15 minutes and get
immediate medical attention.
(5)
Apply anti-corrosion silicone compound to
inside of rear lamp socket (10).
(6)
Install rear lamp (9) in rear lamp socket
(10).
(7)
Install lens cover (7) with two screws (6) in
light assembly (8).
Adhesives, solvents, and sealing
compounds can burn easily, can
give off harmful vapors, and are
harmful to skin and clothing. To
avoid injury or death, keep away
from open fire and use in
well-ventilated area. If adhesive,
solvent, or sealing compound
gets on skin or clothing,wash
immediately with soap and water.
(8)
Apply corrosive preventive compound to
wire 1435 (12).
(9)
Position ground wire (22) through hole in
rear marker light assembly (18).
(10)
Install LED (25) in rear marker light
assembly (18) and turn 1/4 turn clockwise.
(11)
Install gasket (23), rear marker light
assembly (18), two self-tapping screws
(21), ground wire (22), wire 1435 (20) and
two nuts (19) on rear bracket (24).
(12)
Install lens cover (17) with two screws (16)
in rear marker light assembly (18).
19
16
20
24
23
18
21
17
25
22
|
