|
| |
TM 9-2320-364-20-4
7-294
7-89. BATTERY BOX AND SHUNT REPAIR (CONT).
(3)
Install three moldings (14) in battery box (7).
(4)
Install two brackets (13), screws (12) and locknuts (11) on battery box (7).
Corrosion inhibitor contains alkali. Do not get in eyes; wear goggles/safety glasses when using.
Avoid contact with skin. In case of contact, immediately wash area with soap and water. If
eyes are contacted, flush eyes with large amounts of water for at least 15 minutes and get
immediate medical attention.
NOTE
Threads of screws, nuts, and washers will be coated with bituminous coating compound,
during battery installation.
(5)
Coat four battery holddown screws (10) excluding the threads with bituminous coating compound.
(6)
Install four battery holddown screws (10) up through bottom of battery box (7) and four nuts (two on
front, two on rear) (8) on screws.
(7)
Install two rear clips (9) on rear holddown
screws (10).
(8)
Install shunt (4), four locknuts (6) and
screws (5) on battery box (7).
(9)
Install cable (3), lockwasher (2) and
screw (1) on shunt (4).
|
