|
| |
TM 9-2320-364-20-5
18-17
(4)
Install four connectors (47) on ON/OFF
switch (46).
NOTE
OFF position of switch points to
rubber key of washer.
(5)
Install ON/OFF switch (46) in box (2) with
washer (45), rubber washer (44), nylon
washer (43), switch guard (41), lockwasher
(44) and nut (42).
(6)
Install rubber washer (40) and
receptacle (39) in box (2) with
lockwasher (38) and nut (37).
(7)
Install cap (36) on receptacle (39).
(8)
Install plastic washer (34), chain (33) and
plastic washer (32) on stud (35) with
locknut (31).
NOTE
If circuit board was not replaced,
go to Step (10).
(9)
Position heat sink (30) on circuit board (29).
(10)
Install circuit board (29) on controller (18).
NOTE
Spacer is installed only if circuit
board was replaced.
(11)
Install spacer (28) and heat sink (27) on
circuit board (29) with three lockwashers
(26) and screws (24) and (25).
|
