|
| |
TM 9-2320-364-20-5
20-3
b.
Disassembly.
(1)
Remove grease fitting (1) from slip yoke (2).
NOTE
Matchmark slip yoke and splined
yoke to aid in installation.
(2)
Loosen dust cap (3) and separate splined
yoke (4) and slip yoke (2).
(3)
Remove two bearing caps (5) from
U-joint (6). Discard bearing caps.
(4)
Place splined yoke (4) in vise.
Use care when removing
retaining rings. Retaining rings
are under spring tension and can
act as projectiles when released
and could cause severe eye
injury.
(5)
Remove two spring clips (7) from splined
yoke (4).
(6)
Using a soft-faced hammer, drive U-joint (6)
toward bearing cap (8) until it bottoms
against splined yoke (4).
(7)
Rotate splined yoke (4) 1/2 turn in vise.
(8)
Using a soft-faced hammer, drive U-joint (6)
toward bearing cap (9) until it bottoms
against splined yoke (4).
(9)
Remove U-joint (6) from splined yoke (4).
Discard U-joint.
(10)
Using a punch, remove bearing caps (8)
and (9) from splined yoke (4) . Discard
bearing caps.
|
