|
| |
TM 9-2320-364-20-5
20-5
c.
Cleaning/Inspection.
Drycleaning Solvent (P-D-680) is TOXIC and flammable. Wear protective goggles, face
shield, and gloves; use only in a well-ventilated area; avoid contact with skin, eyes, and
clothes, and do not breathe vapors. Keep away from heat or flame. Never smoke when using
solvent. The flashpoint for Type II Drycleaning Solvent is 140 degrees F (60 degrees C) and
Type III Drycleaning Solvent is 200 degrees F (93 degrees C). Failure to do so may result in
injury or death to personnel.
If personnel become dizzy while using cleaning solvent, immediately get fresh air and
medical help. If solvent contacts skin or clothes, flush with cold water. If solvent contacts
eyes, immediately flush eyes with water and get immediate medical attention.
Compressed air used for cleaning purposes will not exceed 30 psi (207 kPa). Use only with
effective chip guarding and personal protective equipment (goggles/shield, gloves, etc).
(1)
Clean all parts with drycleaning solvent.
(2)
Wipe parts with a clean, lint free cloth.
(3)
Inspect all parts for cracks, gouges and pitting.
(4)
Inspect shaft for free play caused by worn slip yoke or shaft splines.
(5)
Replace any cracked or worn parts.
d.
Assembly.
NOTE
Ensure yokes are aligned with
match marks made during
disassembly.
(1)
Place bracket (14) in vise.
(2)
Position U-joint (11) in bracket (14).
Needle bearings may fall out
during assembly, use caution to
avoid damage to equipment.
(3)
Install bearing caps (16) and (17) on
U-joint (11) in bracket (14).
|
