|
| |
TM 9-2320-364-20-5
20-7
(10)
Position U-joint (6) in splined yoke (4).
Needle bearings may fall out
during assembly, use caution
during assembly to avoid damage
to equipment.
(11) Install bearing caps (8) and (9) on
U-joint (6) in splined yoke (4).
Use care when installing
retaining rings. Retaining rings
are under spring tension and can
act as projectiles when released
and could cause severe eye
injury.
NOTE
Clips are properly installed when
seated in grooves in yoke.
(12)
Install two clips (7) in splined yoke (4).
(13)
Remove splined yoke (4) from vise.
(14)
Install bearing caps (5) on U-joint (6).
(15)
Install dust cap (3) and splined yoke (4) on
slip yoke (2).
(16)
Install grease fitting (1) in slip yoke (2).
|
