|
| |
TM 9-2320-364-20-5
20-19
NOTE
Perform Steps (4) through
(22) if replacing fan control
solenoid valve and electrical
connector.
Wires in Step (4) are
fabricated from bulk 16 ga.
wire by 5 in. (12.7 cm) long.
(4)
Insert 1 in. (2.5 cm) of two wires (15)
through dust boots (16).
Strip wire after placing it through
dust boot to prevent damage to
individual wire strands.
(5)
Strip ends of two wires (15) leaving 1/4 in.
(0.64 cm) of bare wire.
(6)
Insert terminal (17) in locating hole of
weatherpac crimper using proper hole
according to the gage of wire (15).
(7)
Slide seal (16) down to end of insulation
(18) on wire (15).
|
