|
| |
TM 9-2320-364-34-2
8-23
Materials/Parts
Adhesive (Item 1, Appendix B)
Grease (Item 21, Appendix B)
Sealing Compound (Item 54, Appendix B)
This task covers:
a. Removal
b. Installation
c. Follow-On Maintenance
INITIAL SETUP
Personnel Required
Two
Equipment Condition
Engine OFF, (TM 9-2320-364-10)
Wheels chocked, (TM 9-2320-364-10)
Driveshaft disconnected, (TM 9-2320-364-20)
Transfer case drained, (TM 9-2320-364-20)
Tools and Special Tools
Tool Kit, General Mechanic’s
(Item 240, Appendix F)
Drill Set, Twist (Item 48, Appendix F)
Drill, Electric, Portable, 1/4 in.
(Item 49, Appendix F)
Installer, Seal, Transfer Case
(Item 119, Appendix F)
Wrench Set, Socket 3/4 in. Drive
(Item 274, Appendix F)
Wrench, Torque (0-600 lb-ft [0-814 N.m])
(Item 278, Appendix F)
Holder, Flange (Appendix C)
Screw, Sheet Metal, No. 8 by 1 in. (2)
Washer 3/16 in. (2)
8-4. TRANSFER CASE YOKE AND OIL SEAL REPLACEMENT.
NOTE
There are three transfer case yokes. Lower rear yoke is shown.
To remove front yoke, perform Step (1).
To remove rear yoke, perform Step (2).
(1)
With the aid of an assistant, use flange holder and remove screw (1) and retainer washer (2) from front
yoke end (3).
(2)
With the aid of an assistant, use flange holder and remove screw (1), washer (4) and retainer washer (2)
from rear yoke end (3).
(3)
Remove yoke end (3) from transfer case (5).
|
