|
| |
TM 9-2320-364-34-2
8-24
8-4. TRANSFER CASE YOKE AND OIL SEAL REPLACEMENT (CONT).
(4)
Position drain pan under bearing cover (6).
Protective goggles must be worn
when drilling holes. Failure to
comply may result in injury to
personnel.
(5)
Drill two 1/8 in. (3.2 mm) holes directly
opposite each other in seal casing (7).
(6)
Install two washers (8) and sheet metal
screws (9) in drilled holes.
NOTE
Seal is removed by prying against
washers with pry bar.
(7)
Remove and discard oil seal (7) from
bearing cover (6).
b.
Installation.
(1)
Coat lip of oil seal (7) with grease.
NOTE
Installer is only used on two
bottom output seals.
Ensure that lip of seal is
facing inside of bearing.
(2)
Using transfer case seal installer, install oil
seal (7) in bearing cover (6).
|
