|
| |
TM 9-2320-364-34-2
9-40
9-8. AXLE NO. 1, 2, AND 5 CONSTANT VELOCITY JOINT REPAIR (CONT).
(2)
Remove constant velocity shaft (3) from
axle housing (4).
(3)
Remove seal (5) from axle housing (4).
Discard seal.
Use care when removing
retaining rings. Retaining rings
are under tension and can act as
projectiles when released and
could cause injury to personnel.
(4)
Remove retaining ring (6) from axle
housing (4). Discard retaining ring.
(5)
Using mechanical puller, remove bearing (7)
from axle housing (4).
(6)
Remove two grease fittings (8) from
block (9). Discard grease fittings.
(7)
Remove two retaining rings (10) from
block (9). Discard retaining rings.
(8)
Remove two retaining rings (10) from
shaft (11). Discard retaining rings.
(9)
Remove two screws (12) from caps (13).
Discard screws.
(10)
Using inertial extractor and adapter,
remove two caps (13) from cross (14) and
block (9). Discard caps.
(11)
Using a press, remove two caps (15) from
cross (14) and shaft (11). Discard caps.
(12)
Remove cross (14) from shaft (11).
Discard cross.
|
