| |
TM 9-2320-364-34-2
9-101
(14) Coat threads on shaft of torque rod (36) with lubricating oil.
(15) Install tapered shaft of torque rod (36) in axle (37).
NOTE
Tighten locknut only until threads of locknut are fully engaged with threads of torque rod.
Otherwise, other end of torque rod will be difficult to install.
(16) Position washer (38) and locknut (35) on torque rod (36).
NOTE
Install same number and size spacers as noted during removal.
(17) With the aid of an assistant, install spacers (43), bracket (42) and truck end of torque rod (36) on frame
(10) with two screws (40), four washers (41) and two locknuts (39).
(18) Tighten locknuts (35) on torque rod (36) 175 to 225 lb-ft (237 to 305 N.m).
NOTE
To seat torque rod, strike torque rod mount with hammer.
(19) Retighten locknut (35) on torque rod (36) to 175 to 225 lb-ft (237 to 305 N.m).
|