| |
TM 9-2320-364-34-3
16-50
16-3. BOOM ASSEMBLY REPAIR (CONT).
NOTE
Cable may be held with pliers to
tighten locknut.
(126)
Pull cable (8) through base section (4) and
install washer (7), locknut (6) and nut (5)
on cable.
Adhesives, solvents, and sealing
compounds can burn easily, can
give off harmful vapors, and are
harmful to skin and clothing. To
avoid injury or death, keep away
from open fire and use in a well-
ventilated area. If adhesive,
solvent, or sealing compound
gets on skin or clothing, wash
immediately with soap and
water.
NOTE
Perform Steps (127) and (128) if
wear pad has a shim and screw.
(127)
Apply sealing compound to threads of
screw (25).
(128)
Install shim (26) on wear pad (24) with
screw (25).
Do not stick fingers under
section to install wear pads, or
injury to hands may result.
(129)
Lift front of inner-mid section (20) and
install wear pads (24) on inner-mid section.
(130)
Apply grease to two wear pads (24).
|