|
| |
TM 9-2320-364-34-3
18-148
18-13. CONTAINER HANDLING UNIT (CHU) KIT INSTALLATION (CONT).
Stow weldment weighs 410 lbs
(186 kg). Attach suitable lifting
device to prevent possible injury
to personnel.
NOTE
Hardware for mounting stow
weldment can be found in box D,
pack no. 24 of CHU kit crate.
(36)
From CHU kit pallet, attach lifting device
to stow weldment (59).
(37)
With the aid of an assistant, position stow
weldment (59) on front support assembly
(51).
(38)
Install stow weldment (59) on front support
assembly (51) with four screws (60) and
locknuts (61).
(39)
Rotate two deck weldments (55) towards
rear of truck.
NOTE
Measurements should be
taken on both sides of cone
weldment.
If measurement “A” is not
18.1 in. (46 cm) 0.125 in.
(3.18 mm), perform Steps
(42) and (45).
If measurement “A” is 18.1
in. (46 cm) 0.125 in. (3.18
mm), go to Step (41).
Cone weldment shims are
already installed. Remove
shims as required.
(40)
Measure distance between base of cone
weldment (62) and bottom of pivot pin
(63). Record as measurement “A”.
51
60
59
63
62
61
55
A
55
|
