|
| |
TM 9-2320-364-34-3
18-207
(22)
Position lifting frame in stowed position
(TM 9-2320-364-10).
NOTE
Ensure rear sliders are deployed
in Step (23).
(23)
Start engine (TM 9-2320-364-10).
Engine speed must be at idle
before using hydraulic selector
switch, or damage to equipment
may result.
(24)
Set hydraulic selector switch (292) to
AUTO.
NOTE
LHS may be extended
approximately 12 in. (30 cm)
after hook arm cylinder stops and
main frame cylinder extends to
make measurement in Step (27)
easier.
(25)
Extend hook arm cylinder (349) until hook
arm cylinder stops and main frame
cylinders (350) starts to move.
(26)
Shut OFF engine.
NOTE
If measurement in Step (27)
is 77 in. 0.25 in. (196 cm
0.64 mm), go to Step (33).
If measurement in Step (27)
is not 77 in. 0.25 in. (196
cm 0.64 mm), perform
Steps (28) through (32).
(27)
With the aid of an assistant, measure
distance between center of two hook arm
cylinder pivot pins (351).
292
STEERING WHEEL
SHOWN REMOVED
FOR CLARITY
349
351
350
351
77 IN. 0.25 IN.
(195.58 CM 0.64 MM)
|
