|
| |
TM 9-2320-364-34-3
18-209
(35)
Remove lifting frame (328) from PLS truck
in flatrack mode (TM 9-2320-364-10).
(36)
Install lifting frame (328) on PLS truck in
container mode (TM 9-2320-364-10).
(37)
Measure gap between bail bar (352) and
hook (353) as shown.
NOTE
Both rubber bumpers are
removed the same way. Right
side shown.
Shims and locknuts can be
found in boxes D and F, pack
no. 16 and 70 of CHU kit
crate.
Shims are 0.104 in. (2.7 mm)
thick.
Add shims to decrease
clearance.
Remove shims to increase
clearance.
If gap is not 0.38 in. 0.25
in. (9.65 mm 6.35 mm),
perform Steps (38) through
(46).
If gap is 0.38 in. 0.25 in.
(9.65 mm 6.35 mm),
perform Step (47).
(38)
Start engine (TM 9-2320-364-10).
(39)
Using LHS, raise lifting frame (328)
approximately 12 in. (30 cm) off of rubber
bumpers (354).
(40)
Shut OFF engine.
(41)
Remove two locknuts (355) and rubber
bumpers (354) from bumper weldment
(356). Discard locknuts.
(42)
Install two rubber bumpers (354), shim(s)
(357), as required, and two locknuts (355)
on bumper weldment (356).
(43)
Repeat Steps (41) and (42) for left side.
353
354
328
352
0.38 IN. 0.25 IN.
(9.65 MM 6.35 MM)
357
356
355
|
