|
| |
TM 9-2320-364-34-3
18-270
18-15. CONVERT DDEC II CAB ASSEMBLY TO DDEC III CAB ASSEMBLY (CONT).
(12)
Position heat shrink (14) over wire 505
(12).
(13)
Remove .25 in. (.6 cm) of insulation from
end of wire 505 (12).
(14)
Install end of wire 505 (12) in butt splice
(15) on wire 953 (16) of kit harness and
crimp using crimping tool.
(15)
Position heat shrink (14) over butt splice
(15) and heat using heat gun.
(16)
Insert removal tool in position A (17) of
M13 connector (3) until seated.
(17)
Remove wire 435 (18) from position A (17)
on MC13 connector (3) and removal tool.
(18)
Cut off terminal (19) and wire seal (20)
from end of wire 435 (18). Discard
terminal and wire seal.
(19)
Install heat shrink (21) over end of wire
435 (18) and seal using heat gun.
(20)
Install wire 953 (22) of kit harness in
position A (17) of MC13 connector (3).
|
