|
| |
TM 9-2320-364-34-3
18-272
18-15. CONVERT DDEC II CAB ASSEMBLY TO DDEC III CAB ASSEMBLY (CONT).
(28)
Install plug (30) in position B (25) on
MC106 connector (23).
(29)
Install wire 953 (32) of kit harness in
position D (31) on MC106 connector (23)
until seated.
(30)
Close two secondary locks (24) on MC106
connector (23).
(31)
Unlatch and open two secondary locks (33)
on MC106 connector (23).
Tip of removal tool is very sharp.
Use caution when using tool.
Failure to comply may result in
injury to personnel.
(32)
Insert removal tool into position B (34) on
MC106 connector (23) until seated.
(33)
Pull wire 505 (35) back through MC106
connector (23) and remove tool.
(34)
Remove plug (36) from position D (37) on
MC106 connector (23).
|
