|
| |
TM 9-2320-364-34-4
20-279
Use care when installing spring.
Spring is under tension and can
act as a projectile if released and
could cause severe eye injury.
(2)
Install valve (26), spring (25), copper
washer (24) and plug (23) in oil cooler
adapter (15). Tighten plug
25 to 30 lb-ft (34 to 41 N.m).
Adhesives, solvents, and sealing compounds can burn easily, can give off harmful vapors, and
are harmful to skin and clothing. To avoid injury or death, keep away from open fire and use
in a well-ventilated area. If adhesive, solvent, or sealing compound gets on skin or clothing,
wash immediately with soap and water.
(3)
Apply sealing compound to threads of 14 screws (16) and (18).
(4)
Install two shims (20) and (21), gaskets (19) and oil cooler adapter (15) with three washers (17)
and screws (16). Tighten 30 to 35 lb-ft (41 to 47 N.m).
(5)
Install three screws (18). Tighten 30 to 35 lb-ft (41 to 47 N.m).
(6)
Apply grease to gasket (14).
(7)
Install gasket (14) and oil cooler adapter cover (9), with eight lockwashers (13) and screws (12) on
engine block (22). Tighten screws 120 to 156 lb-in (14 to 18 N.m).
|
