|
| |
TM 9-2320-364-34-4
20-281
Materials/Parts
Oil, Lubricating (Item 36, Appendix B)
This task covers:
a. Installation
b. Follow-On Maintenance
INITIAL SETUP
Equipment Condition
Engine oil cooler assembly installed,
(Para 20-83)
Tools and Special Tools
Tool Kit, General Mechanic’s
(Item 240, Appendix F)
Wrench, Torque (0 to 175 lb-ft [0-237 N.m])
(Item 277, Appendix F)
20-84. ENGINE OIL FILTER AND SPIN-ON ADAPTER HOUSING AND
REMOTE ENGINE OIL FILTER MANIFOLD INSTALLATION.
Materials/Parts - Continued
Sealing Compound (Item 56, Appendix B)
Gasket (Item 112, Appendix E)
Lockwasher (2) (Item 292, Appendix E)
Spring (Item 659, Appendix E)
a.
Installation.
Use care when installing spring. Spring is under tension and can act as a projectile if
released and could cause severe eye injury.
NOTE
Perform Steps (1) through (3) if truck is not equipped with remote engine oil filter
manifold.
Perform Steps (4) through (8) if truck is equipped with remote engine oil filter manifold.
(1)
Install bypass valve disk (11), spring (10), retainer (9) and screw (8) in housing adapter (2).
Adhesives, solvents, and sealing compounds can burn easily, can give off harmful vapors,
and are harmful to skin and clothing. To avoid injury or death, keep away from open fire
and use in a well-ventilated area. If adhesive, solvent, or sealing compound gets on skin or
clothing, wash immediately with soap and water
(2)
Apply sealing compound to threads of four
screws (3).
(3)
Install gasket (6) and adapter housing (2) on
oil cooler adapter cover (7) with four
screws (3). Tighten screws 30 to 35 lb-ft
(41 to 47 N.m).
|
