| |
TM 9-2320-364-34-4
23-42
Materials/Parts
Cloth, Cleaning (Item 11, Appendix B)
Oil, Hydraulic (Item 34, Appendix B)
Solvent, Drycleaning (Item 68, Appendix B)
Lockstrip (6) (Item 225, Appendix E)
Retaining Ring (Item 475, Appendix E)
Seal Ring (Item 609, Appendix E)
Seal Ring (Item 611, Appendix E)
This task covers:
a. Removal
c. Cleaning/Inspection
e. Installation
b. Disassembly
d. Assembly
f. Follow-On Maintenance
INITIAL SETUP
Personnel Required
Two
Equipment Condition
Torque converter stator removed, (Para 23-10)
Tools and Special Tools
Tool Kit, General Mechanics
(Item 240, Appendix F)
Compressor Unit, Air (Item 35, Appendix F)
Gloves, Chemical Oil Protective
(Item 81, Appendix F)
Goggles, Industrial (Item 83, Appendix F)
Gun, Airblow (Item 86, Appendix F)
Puller, Mechanical (Item 173, Appendix F)
Puller, Bolts (Item 172, Appendix F)
Remover, Snap Ring (Item 191, Appendix F)
Sleeve Puller (Item 202, Appendix F)
Wrench, Torque (0 to 175 lb-ft [0-237 N.m])
(Item 277, Appendix F)
23-11. TORQUE CONVERTER PUMP REPAIR.
a.
Removal.
(1)
Position transmission assembly so torque
converter housing (1) faces up.
Use care when removing
retaining rings. Retaining rings
are under tension and can act as
projectiles when released
causing injury to personnel.
(2)
Using snap ring remover, remove and
discard retaining ring (2) from ground
sleeve (3).
(3)
Remove spacer (4) from ground sleeve (3).
(4)
Bend corners of two lockstrips (5) away
from heads of two screws (6) exactly
opposite each other on bearing retainers (7).
(5)
Remove two screws (6) from lockstrips (5).
|