|
| |
TM 9-2320-364-34-4
23-63
e.
Installation.
Seal rings are in air tight package. Do not open package until ready to install seal ring. Seal
ring will expand from humidity which will cause clutch piston cavity to leak and cause clutch
slippage.
(1)
Position two seal rings (1) in forward clutch hub (2) and measure end clearance of seal rings. Remove
seal rings. If end clearance is less than 0.015 in. (0.381 mm), discard seal ring and repeat this Step.
(2)
Pack seal ring grooves of torque converter housing support hub (3) with grease and install two seal
rings (1).
Seal rings are in air tight package. Do not open package until ready to install seal ring. Seal
ring will expand from humidity which will cause clutch piston cavity to leak and cause clutch
slippage.
(3)
Position seal rings (4) in torque converter housing support hub (3) and measure end clearance of seal
rings. Remove seal rings. If end clearance is less than 0.015 in. (0.381 mm), discard seal rings and
repeat this step.
(4)
Pack seal ring grooves on turbine shaft (5) with grease and install seal rings (4) on turbine shaft.
|
