|
| |
TM 9-2320-364-34-4
23-73
d.
Assembly.
NOTE
Perform Steps (1) through (8)
only if PTO gear and oil
collector ring was removed.
(1)
Position forward clutch housing (1),
turbine shaft (2), down in press.
Use care when installing
retaining rings. Retaining rings
are under tension and can act as
projectiles when released causing
injury to personnel.
(2)
Install retaining ring (3) in groove (4) in
forward clutch housing (1).
Ensure personnel wear heat resistant gloves prior to heating PTO gear with propane torch.
Failure to comply may result in severe injury or death to personnel.
(3)
Heat PTO gear (5) with propane torch.
(4)
Install PTO gear (5), chamfered side first, on forward clutch housing (1) until retaining ring (3) expands
into PTO gear groove.
(5)
Position forward clutch housing (1) and turbine shaft (2) upward on work table.
Adhesives, solvents, and sealing compounds can burn easily, can give off harmful vapors,
and are harmful to skin and clothing. To avoid injury or death, keep away from open fire
and use in a well-ventilated area. If adhesive, solvent, or sealing compound gets on skin or
clothing, wash immediately with soap and water.
(6)
Apply retaining compound onto bonding surface of forward clutch housing (1) and install oil collector
ring (6) on forward clutch housing.
(7)
Use installer to seat collector ring (6) on forward clutch housing (1).
NOTE
Entire circumference of oil collector ring should be bent in groove in forward clutch housing.
(8)
Using staking tool, bend edge of oil collector ring (6) in groove in forward clutch housing (1).
|
