|
| |
TM 9-2320-364-34-4
23-74
23-13. FORWARD CLUTCH AND TURBINE SHAFT REPAIR (CONT).
(9)
Position collector ring installer in press.
(10)
Install forward clutch and turbine shaft
assembly (7) and turbine shaft (2) down, on
collector ring installer in press.
(11)
Apply hydraulic oil to gasket (8) and
seal (9).
NOTE
Gasket and seal are installed
with lip facing down away from
tangs of forward clutch piston.
(12)
Install gasket (8) and seal (9), lips down, on
forward clutch piston (10).
(13)
Install inner hub seal protector over inner
hub of forward clutch housing (7).
(14)
Install forward clutch piston (10) over seal
protector. Carefully work piston
completely down until seated.
(15)
Remove inner hub seal protector from
forward clutch housing (7).
(16)
Install 20 piston release springs (11) on
forward clutch piston (10).
Use care when installing retaining rings. Retaining rings are under tension and can act as
projectiles when released causing injury to personnel.
NOTE
Ensure clutch spring compressor tool opening is facing forward.
(17)
Install spring retainer (16) and spring compressor tool on forward clutch piston (10).
(18)
Compress spring retainer (16) with clutch spring compressor tool and install retaining ring (17) in
forward clutch housing (7).
(19)
Slowly release pressure from spring retainer (16) and remove clutch spring compressor tool from
piston (10).
|
