|
| |
TM 9-2320-364-34-4
25-94
25-16. AXLE NO. 2 DIFFERENTIAL ASSEMBLY REPAIR (CONT).
(47)
Remove one of four screws (34).
Adhesives, solvents, and sealing compounds can burn easily, can give off harmful vapors, and
are harmful to skin and clothing. To avoid injury or death, keep away from open fire and use
in well-ventilated area. If adhesive, solvent, or sealing compound gets on skin or clothing,
wash immediately with soap and water.
(48)
Coat threads of screw (34) with sealing
compound.
(49)
Install screw (34) and tighten to 123 to 138
lb-ft (167 to 187 N.m).
(50)
Repeat Steps (47) through (49) for three
remaining screws (34).
(51)
Coat the threads of screw (31) with sealing
compound.
(52)
Install screw (31) in lock plate (32).
(53)
Install fork (27) in housing assembly (15)
with retaining pin (30).
(54)
Stake retaining pin (30) on largest diameter
end.
(55)
Coat both ends of retaining pin (30) with
adhesive.
(56)
Install two finger forks (29) in fork (27).
Use care when installing
retaining rings. Retaining rings
are under tension and can act as
projectiles when released and
could cause severe eye injury.
(57)
Install clutch gear (28) on fork (27) with
retaining ring (26).
|
