| |
TM 9-2320-364-34-4
25-162
25-28. AXLE NO. 3 DIFFERENTIAL ASSEMBLY REPAIR (CONT).
(17)
Install taper bearing (66) on pinion shaft (1).
(18)
Install spacer (65) on pinion shaft (1).
(19)
Install pinion shaft (1) and bearing (64) in
housing (26).
(20)
Position jet extractor between gear teeth of
bevel gear (2) and housing (26).
(21)
With the aid of an assistant, install spanner
nut (63). Tighten spanner nut to 528 to 564
lb-ft (716 to 765 N.m).
NOTE
If preload is incorrect refer to
Step (10). If preload is correct go
to Step (23).
(22)
Check preload on pinion shaft (1) by turning
spanner nut (63) with a torque wrench.
Preload must be 2 to 3 lb-ft (3 to 4 N.m).
(23)
Stake spanner nut (63) in two places.
(24)
Install taper bearings (61) and (62) on
differential gear (3).
(25)
Adjust the adjusting shim (60) thickness by
applying the opposite change of thickness
applied to adjusting shim (70) in Step (10).
(26)
Install adjusting shim (60) and bearing
races (58) and (59) on differential gear (3).
|