REAR MARKER LIGHT(S) DO NOT OPERATE. (Cont) -725550361

TM 9-2330-385-14

Remove all jewelry such as rings, dog tags, bracelets, etc. If jewelry or tools contact positive electrical

circuits, a direct short may result. Damage to equipment, injury, or death to personnel may occur.

CONTINUITY TEST

(1) Set multimeter select switch to ohms.

(2) Is continuity measured between

ground side of marker light socket

and a known good ground.

(a) If there is no continuity, replace

rear marker light (Para 4-28).

(b) If there is continuity, rear marker

light is OK. Fault not corrected.

Notify supervisor.

CONTINUITY TEST

(1) Disconnect wire 1012-31 connector.

(2) Is there continuity between connector

and center contact and connector?

(a) If there is no continuity, replace

rear marker light (Para 4-28).

(b) If there is continuity, marker light

is OK.

(3) Install light lamp.

(4) Install marker light lens and

two screws.