|
|
![]() TM 9-2330-385-14
Remove all jewelry such as rings, dog tags, bracelets, etc. If jewelry or tools contact positive electrical
circuits, a direct short may result. Damage to equipment, injury or death to personnel may occur.
CONTINUITY TEST
(1) Disconnect 12 vdc cable from
connector MC16.
(2) Set multimeter select switch to
ohms.
(3) Is continuity measured between
12 vdc cable, pin A and a known
good ground?
(a) If there is no continuity, repair
12 vdc cable (Para 4-31)
or replace 12 vdc cable
(b) If there is continuity, perform
Step (4) below and go to
Step 2 of this fault.
(4) Connect 12 vdc cable to connector
MC-16.
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |