Figure 32. Install the Armored Door Assembly to the cab (driver's-side door shown).

II106700-5

Rev. B

Page 52

Figure 32. Install the Armored Door Assembly to the cab (driver's-side door shown).

c. Check the Armored-Door-Assembly-to-cab fit and alignment, and adjust the door

and/or latch pin as necessary until the alignment is correct.

NOTE

If necessary, washers or shims may be placed between the door latch assembly and the

door to adjust the latch inboard if the latch is not completely engaging the striker. Shim

adjustment should not exceed 3/16 in.

d. Tighten the ten bolts (3/8 16 x 1.500 LG) to secure the Armored Door Assembly in

place. Torque the bolts to 18 ft-lb.

NOTE

The protective paper that is attached to the transparent Window Armor Panels is

removed during the first installation. Subsequent Window Armor Panel

installation will not have this protective paper, and the cleaning decal will already

be installed on the Window Armor Panel. Use care when handling the Window

Armor Panels to avoid breaking / chipping / scratching them.

0039 00-62