DRAFT
TB 9-2320-364-13&P-1
AC HEATER/EVAPORATOR BLOWER MOTOR RESISTOR HARNESS
REPLACEMENT
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
THIS WORK PACKAGE (WP) COVERS:
Removal
Installation
Follow-On Maintenance
INITIAL SETUP:
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
Maintenance Level
Materials/Parts
Field Level Maintenance
Tags, Identification (Item 10, Appendix E)
Tape, Insulation, Electrical (Item 11, Appendix E)
Equipment Condition
Lockwashers (4) (Item 4, Figure 5, Appendix G)
Batteries disconnected (TM 9-2320-364-20).
Personnel Required
Heater/defroster tubing (upper plenums) removed
(TM 9-2320-364-20).
One
Tools and Special Tools
References
Tool Kit, Electrical (Item 8, Appendix F)
TM 9-2320-364-20
Tool Kit, General Mechanic's (Item 9, Appendix F)
REMOVAL
PLSAC067
NOTE
Tag and mark wires and connectors prior to removal to ensure proper installation.
1. Remove screw (1), lockwasher (2), washer (3), and ground wire (4) from heater/evaporator (5). Discard
lockwasher.
2. Remove three screws (6), lockwashers (7), washers (8), and cover (9) from heater/evaporator (5).
Discard lockwashers.