TB 9-2320-364-13&P-1
11. Install screw (20) in flywheel housing (19)
with washer (16) and nut (15). Tighten
nut (15) to 25-30 lb-ft (34-41 Nm).
12. Install fitting (21) on fuel return line (13).
13. Install fuel hose extension (22) on
fitting (21).
14. Cap open end of fuel hose extension (22).
NOTE
Use cable ties as required to secure wire
harnesses forward of flywheel housing,
so that wire harnesses do not come in
contact with two compressor drive belts
that will be installed in later steps.
15. Secure wire harness (23) with cable ties as
required.
16. Remove four screws (24) and lockwashers (25)
from cam drive cover (26).
17. Remove screw (27) and washer (28) from cam
drive cover (26).
18. Remove cam drive cover (26) and gasket (29)
from flywheel housing (19).
19. Remove two screws (30) and lockwashers (31)
from transmission (32). Discard lockwashers.
0055-12