TB 9-2320-364-13&P-1
22. Install drive plate (37) and camshaft nut lock plate (35) on camshaft gear (36) with four screws (38).
Tighten four screws (38) to 45 lb-ft (61 Nm).
23. Remove rag from cavity.
24. Install bearing (39) in retainer (40) with lock ring (41).
25. Apply grease to two sides of gasket (42).
26. Position drive shaft (43) in retainer (40).
27. Install drive shaft (43), gasket (42) and retainer (40) on flywheel housing (19) with five lockwashers (44)
and screws (45).
28. Install spacer (46) in retainer (40).
29. Install oil seal (47) in retainer (40).
30. Install pulley (48) on drive shaft (43) with key (49) and nut (50).
0055-14