TB 9-2320-364-13&P-1
CAUTION
Wire 1082 and wire 1052 being cut in
Steps (50) and (51) are from the cab
wiring harness. Do not cut wire 1082
coming from the circuit breaker installed
in Step (47). Failure to comply may result
in damage to equipment.
50. Cut wire 1082 (79) below terminal (80). Discard
terminal (80).
51. Cut wire 1052 (81) below lamp socket (82). Discard
lamp socket (82).
52. Install heat shrink (83) on end of cut
wire 1082 (79).
53. Install end of lighting wire harness (84)
on end of cut wire 1052 (81) with butt
splice (85).
54. Install ring terminal (86) of lighting wire
harness (84) on heater/evaporator (4)
with screw (87), lockwasher (88) and
washer (89).
55. Install bulb (90) in lighting wire
harness (84).
56. Install lighting wire harness (84) and
bulb (90) in light source (91).
57. Install clip (92) on panel (93).
58. Install light source (91) on clip (92).
0055-46