TB 9-2320-364-13&P-2
DOOR ASSEMBLY REPLACEMENT - CONTINUED
0015 00
REMOVAL - CONTINUED
1
13
10,11,12
14,15,16
17
417-047
CLEANING AND INSPECTION
Clean and inspect all parts IAW General Maintenance Instructions (WP 0011 00).
INSTALLATION
WARN I N G
Use extreme caution when handling heavy parts. Provide adequate support and use assistance during proce-
dure. Ensure that any lifting device used is in good condition and of suitable load capacity. Keep clear of
heavy parts supported only by lifting device. Failure to follow this warning may cause injury or death to per-
sonnel.
N OT E
Door assembly weighs 329 lb (149 kg).
1.
If necessary, install two lifting links (13), washers (11), bolts (10), and new locknuts (12) on door assembly (1).
2.
Attach sling and lifting device to lifting links (13) at top of door assembly (1).
3.
Use lifting device to position door assembly (1) on hinge (17).
4.
Install 10 bolts (16), 20 washers (15), and 10 new locknuts (14) through hinge mounting holes on door assembly (1).
Hand tighten locknuts.
5.
Check alignment between door assembly (1) and cab opening. Adjust door assembly and/or latch pin as necessary until
alignment is correct.
6.
Tighten 10 locknuts (14) to 18 lb-ft (24 Nm).
7.
Remove sling and lifting device from lifting links (13).
0015 00-3
Change 1
