TB 9-2320-364-13&P-2
UPPER BRUSH GUARD REPLACEMENT - CONTINUED
0018 00
INSTALLATION - CONTINUED
3.
Use lifting device and align upper brush guard (3) with front of vehicle.
WARN I N G
Use caution when using adhesives and sealants. Prolonged inhalation of vapors can cause lung irritation.
Contact with skin can cause dermatitis. Wear gloves and safety goggles and use product in a well-ventilated
area away from open flame. If ingested, keep individual calm and seek medical attention. DO NOT induce
vomiting. If contact with skin or eyes is made, flush thoroughly with water. Dispose of cleanup rags IAW
local policy and ordinances. Failure to follow this warning may cause injury to personnel.
N OT E
Fully tighten bolts only after lower brush guard is installed.
4.
Apply thread adhesive to two bolts (1). Install two washers (2) and bolts (1) to upper brush guard (3) in fourth and fifth
bolt holes from driver's side. Hand tighten bolts.
2
1
3
417-020
5.
Remove lifting device and sling from upper brush guard (3).
6.
Install lower brush guard (WP 0019 00).
END OF WORK PACKAGE
0018 00-5/(0018 00-6 Blank)