TB 9-2320-364-13&P-2
LOWER BRUSH GUARD REPLACEMENT - CONTINUED
0019 00
CLEANING AND INSPECTION
Clean and inspect all parts IAW General Maintenance Instructions (WP 0011 00).
INSTALLATION
WARN I N G
Use extreme caution when handling heavy parts. Provide adequate support and use assistance during proce-
dure. Ensure that any lifting device used is in good condition and of suitable load capacity. Keep clear of
heavy parts supported only by lifting device. Failure to follow this warning may cause injury or death to per-
sonnel.
N OT E
Lower brush guard weighs 316 lb (143 kg).
1.
Attach two lifting links, sling, and lifting device to top edge of lower brush guard (3). Use lifting device to support lower
brush guard, as needed, to allow installation of components.
2.
Install six stud plates (29) to lower brush guard (3) with six washers (28), bolts (27), washers (31), and new locknuts
(30).
3.
Install two spacers (34) to outside edges of lower brush guard (3) with four washers (35), bolts (36), washers (33), and
new locknuts (32).
4.
Install blackout light bracket (24) to lower brush guard (3) with washer (23), bolt (22), washer (25), and new
locknut (26).
5.
With assistance, lift lower brush guard (3) into position at front of vehicle.
0019 00-5