TM 5-3990-263-13&P
0014
OPERATION - Continued
15.
Move joystick (Figure 7, Item 18) to UNLOAD until bottom tip of LHS lift hook (Figure 7, Item 19) is just below
level of BAP bail bar (Figure 7, Item 20).
16.
Set HIGH IDLE switch (Figure 7, Item 17) to OFF position.
NOTE
Dashboard parking brake indicator will go out when PARKING BRAKE control is released.
17.
Push in PARKING BRAKE control (Figure 7, Item 1), or release service brake pedal (Figure 7, Item 2).
18.
Place transmission range selector (Figure 7, Item 3) to R (reverse), and back up vehicle until LHS lift hook
(Figure 7, Item 19) engages BAP bail bar (Figure 7, Item 20).
19.
Set transmission range selector (Figure 7, Item 3) to N (neutral).
20.
Pull out PARKING BRAKE control (Figure 7, Item 1), or apply service brake pedal (Figure 7, Item 2).
CAUTION
Both trailer bumper points must be under vehicle bump plate and at least one trailer
bumper point must contact bump plate. Trailer bumper point not contacting vehicle
bumper stop cannot exceed 0.5 in. (12.7 mm) or the BAP will miss main rail guides.
Failure to comply may result in damage to equipment.
Do not shift transmission to reverse to back up vehicle while LHS hook arm is attached
to the BAP. Failure to comply may result in damage to equipment.
21.
Ensure trailer bumper point (Figure 8, Item 21) is under flange of vehicle bump plate (Figure 8, Item 22).
22
21
Figure 8. Trailer Bumper Point and Vehicle Bump Plate.
03/15/2011Rel(1.8)root(opusualwp)wpno(O01065)
