TM 5-3990-263-13&P
OPERATOR MAINTENANCE
WINCH ASSEMBLY WILL NOT WIND IN
INITIAL SETUP:
Equipment Condition (cont.)
References
Parking brakes applied. (TM 9-2320-435-10 or
TM 9-2320-425-10) (WP 0076)
Wheels chocked. (TM 9-2320-435-10 or
TM 9-2320-425-10) (WP 0076)
Equipment Condition
BAP loaded on vehicle. (WP 0005)
Engine started. (TM 9-2320-435-10 or TM
9-2320-425-10) (WP 0076)
TROUBLESHOOTING PROCEDURE
SYMPTOM
Winch Assembly will not Wind in.
MALFUNCTION
Winch Assembly Switch not Set Correctly.
CORRECTIVE ACTION
Ensure winch assembly switch on remote control unit is set to IN (Figure 1). (WP 0004)
WINCH
REMOTE
ASSEMBLY
CONTROL
SWITCH
UNIT
Figure 1. Winch Assembly Switch.
a.
If winch assembly switch is not set correctly, set switch to IN position.
b.
If winch assembly switch is set correctly, proceed to next Malfunction.
